Call us to get tree assist just as tree cleanup, tree grinding, bush hauling, shrub clear, stump cutter and a lot of other around USA.


Call us now

Call us now +1 (855) 280-15-30






Although there were a variety of C4 castings produced between and, there are.

stump grinder hire cost brisbane, 2370 Rockland MA Oct 13, - F & Larger F-Series Trucks - C4 tailshaft bushing replacment - Now iknow this has been talked about but icant find exactly what im looking for.

my girlfrind has a 79 f it has a c4 and needs a tailshaft bushing because it moves a good amount when you grab the drive shaft and move it around. i know i. Jul 23, The tail housing bolts use a 9/16" wrench as do most of the cross member bolts. The transmission support/mount uses 3/4 wrench to the ones that screw into the tail housing and the drive shaft u-bolts are 1/2" wrench.

_____ Larry 96 Ford F PSD CC DRW 97 Ford Taurus 64 Fairlaine rust bucket/future Tbolt clone with BBFEstimated Reading Time: 2 mins. Jul 05, The part numbers are T and T The combination set is T Here is a link to the original catalog: Tools_Kit_treeclear.buzz The 20 piece set sells foron ebay.

Here is the link: SST Transmission Bushing Driver treeclear.buzzted Reading Time: 7 mins. May 09, Posts. #2 May 8, take the tailshaft housing off,not that bad of a job,take out speedo cable,take trans.

Performance Automatic has this larger intermediate band servo for C4 transmissions.

mount bolts out,jack up trans. with 2x4 under pan,take treeclear.buzz member bolts out and let it hang down,take bolts out of tailshaft and slid tailshaft off,they do have a tool to remove and a tool to install tailshaft bushing Estimated Reading Time: 2 mins. Feb 14, The output shaft in my 65 C4 automatic seems to have excessive play since it wiggles back and forth about 1/4 inch either way.

Due to a sever driveline vibration at 60 mph, I took my driveshaft in for a complete rebuild and a brand new slip yoke.

The low-reverse servo piston should always be replaced.

I am thinking that the tailshaft bushing in my. Tool Number: J Tool Name: Bushing and Bearing Remover - ( inch) Applications: Camaro with Aisin or Tremec Transmission The rear seal on manual transmissions is installed deep into its bore in the extension housing.

J is used with either a slide hammer or J Puller Bridge to remove the seal without scratching the bore. Jun 17, FYI: There is always play in the output shaft of a C4 with the driveline out. It rides in a bushing that is at the rear of the main case and there has to be clearance in that bushing for oil.

That clearance is magnafied when measured 18" away at the end of the output shaft. I bet there is almost no slop at all with the driveline in it. Oct 19, I'm going to be replacing the extension housing seal and bushing on my Ford E L L6. I've already replaced the u-joints. The seal has some tears and leaks a bit and there is a lot of play on the output shaft of the transmission.

The transmission itself is the 3-speed C6. In the Ford. Ford’s C4 Cruise-O-Matic and Select-Shift 3-speed automatic transmission is a light-duty unit intended for six-cylinder and small-block V-8 engines. Versions of the C4 have also been produced for big-blocks.

The C4 was produced from through at Ford’s Sharonville, Ohio, transmission plant.